| ELECTRICAL CHARACTERISTICS (VOLTAGE STATUS) | P150 SERIES |
| Typical values are at 25 ± 5° C INPUT |
DEVICE WITH VOLTAGE STATUS | LIMITS | UNIT | NOTES | ||
| Parameter | Symbol | CONDITIONS -55°C to +105°C (1) |
MIN | MAX | ||
| Logic supply voltage | VCC | 4.5 | 5.5 | Vdc | ||
| CONTROL voltage high | VIH | 2.0 | Vdc | |||
| CONTROL voltage low | VIL | 0.8 | Vdc | |||
| Transient | Pulse width = 12.5 msec max. per MIL-STD-704D | +50 | Vdc | 2 | ||
| Spikes | Pulse width = 10 µsec max. per MIL-STD-704D | -600 | +600 | Vdc | 2 | |
| REQUIREMENTS | ||||||
| 28 Vdc initialization spike voltage | During of output spike at 50% amplitude shall be 100µsec maximum | 5 | VPR | |||
| 5 Vdc initialization control | Vline = 28 Vdc, Vcontrol = 0 Vdc, Vbias = 0 to 5 Vdc, rated at <1 msec | 3 | ||||
| Logic supply current | ICC | VCC=5.5 Vdc | 50 | mA | 4 | |
| Load current continuous | ILOAD | 100 | %I | |||
| "ON" state voltage drop | VO | 200 | mV | 5 | ||
| Leakage current | IL | 1 | mA | |||
| STATUS & TRIP voltage high | VOH | IOH=5mA | 2.4 | Vdc | ||
| STATUS & TRIP voltage low | VOL | IOL=1mA | 0.4 | Vdc | ||
| CONTROL current high | IIH | VI=2.4 Vdc | 50 | µA | ||
| CONTROL current low | IIL | VI=0.4 Vdc | 10 | µA | ||
| Output "ON" sense voltage | VON | See Timing Diagram (Voltage Status) | 30 | 70 | % | 5,6,7 |
|
Notes: 1. Unless specified otherwise, test conditions shall be at Vcc=5.0±0.25Vdc and Vline=28±0.5Vdc. The design shall be capable of meeting all requirements with Vcc=4.5 to 5.5Vdc. 2. The transient and spike requirements apply only to the 28Vdc power lines. 3. The device output shall remain off when 5V bias is raised from 0 to 5Vdc. |
4. Without any load connected to the STATUS or TRIP outputs. 5. At 100% rated current. 6. Rated resistive load; measurements taken between 10% and 90% points. 7. Percent of actual applied Vline. |
|
| Date of issue: 4/10 | - 12 - | Page 4 of 6 |