[1] The accuracy specification applies for any combination of operating temperature and voltage. 
    For units with a timing range less than 1 second, add ±10 milliseconds to the ±10% tolerance.
[2] Transient and power loss specification are based on a maximum duty cycle of 1/50.
[3] EMI test limits will not be exceeded during the timing interval or when continuously energized
    under steady state conditions, per paragraph 3.23, MIL-PRF-83726C.
[4] Terminals X1, X2, D1 and D3 must be connected together during the test. Dielectric withstanding
    voltage and insulation resistance are measured at sea level between all mutually insulated
	terminals and between all terminals and case.
[5] Recycle time is defined as the maximum time power must be removed from terminal X1 to assure
    that a new cycle can be completed within the specified timing tolerance.
[6] Time delays greater than 500 seconds are not MIL qualified. A four digit number defines the time
    delay in seconds (or milliseconds). The first three digits are significant figures, used to define
    the upper limit of a DECADE RANGE. The fourth digit represents the number of zeros to follow
    the first three digits.
                           SPECIFY     STANDARD DECADE RANGE

                           - 1001   =  0.1 to 1 second (100 to 1000 milliseconds)
                           - 1002   =  1 to 10 seconds
                           - 5002   =  5 to 50 seconds
                           - 5003   =  50 to 500 seconds
    An external resistor is used to obtain a specific time delay within the specified decade range.
    The formula below provides the proper resistance value to achieve the desired time delay:
             T1
    Rext = (_____ - 1)  100,000 Ohms Where:Rext = External resistance value (Ohms)
             T0                               T1   = Desired time in seconds
                                   T0   = Minimum time (low end of the decade range) in seconds.
    As an example, if using a 5 to 50 second adjustable timer and a 30 second delay is desired, the calculation is:
             30
    Rext = (_____ - 1)   100,000 Ohms or Rext = 500 K Ohms
             5
    Recommended resistors IAW MIL-R-55182 1/8 Watt, 1% (RNC60HXXXXFS).
    External resistor not supplied.
[7] Quality level as specified in MIL-R-83726B, paragraph 3.1.1, 3.1.2 and 3.1.3.